TX 1-LT4, 2- Vortec 350 cams for sale - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**WIDESIDE72** · 12-06-2009, 08:41 PM

The first pic is the GMPP LT4 roller cam has the long pin in the end. I think this is for use in an LT1 with Opti Spark. I ran it for about 500 miles in a Vortec 350 before swapping in a Comp Cam RV grind for more torque. sold

The second two are stock Vortec 350 cams. One has around 60k miles. The other was in the rebuilt Vortec short block I bought. I'm not sure if the rebuilder did anything to it or not. $50 each + shipping

High volume oil Pump for 350 Vortec, around 500 miles on it. $20 + shipping

New stock type Vortec 3 pc.single roller timing set ( cam gear, crank gear and chain SOLD

12-06-2009, 08:41 PM	#1
WIDESIDE72 Senior Member Join Date: Aug 2008 Location: Cedar Park, Texas Posts: 7,500	1-LT4, 2- Vortec 350 cams for sale The first pic is the GMPP LT4 roller cam has the long pin in the end. I think this is for use in an LT1 with Opti Spark. I ran it for about 500 miles in a Vortec 350 before swapping in a Comp Cam RV grind for more torque. sold The second two are stock Vortec 350 cams. One has around 60k miles. The other was in the rebuilt Vortec short block I bought. I'm not sure if the rebuilder did anything to it or not. $50 each + shipping High volume oil Pump for 350 Vortec, around 500 miles on it. $20 + shipping New stock type Vortec 3 pc.single roller timing set ( cam gear, crank gear and chain SOLD Attached Images Last edited by WIDESIDE72; 01-26-2010 at 08:18 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.