Front to rear outer floor patch? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

bmrrwolfe · 12-21-2009, 11:20 AM

So i am in the process of repairing the rust on my project truck and the complete outer floor was junk, i cut it out and got a good deal on a rear outer floor patch panel and was going to pick up a front floor patch panel, but then changed my mind to possibly get the one piece outer floor.
This is an example of the patches.
http://www.lmctruck.com/icatalog/cb/full.aspx?Page=22
I have #4 and was going to get a #3 even though i only need the outer first few inches of it, but it doesn't look like it goes all the way back to the rear patch?
So i found a #5 for $90 shipped to me, should i just buy that?

Sorry for the stupid question and one big reason i want the one piece is just a small welder given to me by my dads friend, a lincoln weldpac 100 running a gasless flux core setup and i can not weld to save my life, so i wanna go the easy way and just have one piece.
Thanks!

**special-K** · 12-21-2009, 02:03 PM

The one piece are a real nice way to go.You should check with the Vendors who sponsor this site.The don`t send catalogs all over the country,but they`ll take better care of you and know what they`re talking about..

12-21-2009, 11:20 AM	#1
bmrrwolfe 1970 C10 Join Date: Dec 2007 Location: Cleveland Ohio Posts: 212	Front to rear outer floor patch? So i am in the process of repairing the rust on my project truck and the complete outer floor was junk, i cut it out and got a good deal on a rear outer floor patch panel and was going to pick up a front floor patch panel, but then changed my mind to possibly get the one piece outer floor. This is an example of the patches. http://www.lmctruck.com/icatalog/cb/full.aspx?Page=22 I have #4 and was going to get a #3 even though i only need the outer first few inches of it, but it doesn't look like it goes all the way back to the rear patch? So i found a #5 for $90 shipped to me, should i just buy that? Sorry for the stupid question and one big reason i want the one piece is just a small welder given to me by my dads friend, a lincoln weldpac 100 running a gasless flux core setup and i can not weld to save my life, so i wanna go the easy way and just have one piece. Thanks!

12-21-2009, 02:03 PM	#2
special-K Special Order Join Date: Nov 2004 Location: Mt Airy, MD Posts: 85,851	Re: Front to rear outer floor patch? The one piece are a real nice way to go.You should check with the Vendors who sponsor this site.The don`t send catalogs all over the country,but they`ll take better care of you and know what they`re talking about.. __________________ "BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.