|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-27-2009, 01:16 PM
|
#1 |
|
Registered User
 
Join Date: Dec 2006
Location: Pueblo West
Posts: 264
|
metal fuel lineto the carb?
hey guys,
I want to make a metal fuel line from the fuel pump up to the carb. I had two questions. 1.What fittings will i use to attach to the 90* elbow coming out of the fuel pump. 2. Will an standard 45* double flair work for this application? thanks, just trying to do small little winter jobs to stay busy. ian |
|
|
|
12-27-2009, 01:50 PM
|
#2 |
|
Registered User
Join Date: Jan 2006
Location: Warrington, PA
Posts: 403
|
Re: metal fuel lineto the carb?
had the same issue not to long ago I used 3/8" brake fitting and steel line. I ran it as far as I could up the block to the fuel filter. check out the old thread.
http://67-72chevytrucks.com/vboard/s...d.php?t=352724
__________________
 69 C10 LWB GM 350 crate motor, 3.73 rearend
|
|
|
|
|
12-27-2009, 01:52 PM
|
#3 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: metal fuel lineto the carb?
rubber fuel lines like that are great until the fire
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
12-27-2009, 02:32 PM
|
#4 |
|
Registered User
Join Date: Dec 2006
Location: Pueblo West
Posts: 264
|
Re: metal fuel lineto the carb?
thats exactly what i was looking for thanks guys
|
|
|
|
|
12-27-2009, 02:34 PM
|
#5 |
|
Registered User
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,819
|
Re: metal fuel lineto the carb?
The 3/8 male flair fitting on the line should screw right into the pump but you will need a good tube bender to make the 90 degree bend.
It's probably best to use a piece of welding rod or coat hanger to make your pattern with to get the right bends if you don't have the old tubing. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
