|
02-13-2010, 01:11 PM
|
#1 |
|
Registered User
Join Date: Aug 2009
Location: PA
Posts: 883
|
lowering blocks?
if i have a c10 heavy half, and i installed a flip kit and drop shackles and c-notch, i want 1-3 inches more of drop in the rear, but i dont want the get the hangers, will lowering blocks work with the flip kit right? the flip kit is a mcgaughys btw if that helps, thanks
|
|
|
|
02-13-2010, 05:40 PM
|
#2 |
|
6.0 powered square
Join Date: Feb 2008
Location: Mesquite texas
Posts: 3,459
|
Re: lowering blocks?
you can use the blocks but I would just remove some leafs springs
I had a beltec flip, 2" drop shackles, and 3 leafs out of 8 reaming there was less than a inch of travel with the c-notch, the pumpkin hit the bed floor, the drop shocks were maxed out and the drive shaft rubbed on a cross member  
__________________
Aaron 1980 c-10 short bed lowered, cammed 6.0, 4l80e 3600 stall, smp tune, wilwoods, and flames best time so far best et 7.86 @87 on motor 7.57 90 on a 75 shot Build http://67-72chevytrucks.com/vboard/s...d.php?t=283326 Last edited by flamingbig10; 02-13-2010 at 05:44 PM. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
