Should i put lt1 into my 2wd blazer? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

72gmcshorty · 04-08-2010, 01:45 AM

I have a chance to buy a motor/trans out of 96 corvette. Whats involved in putting this into a 72 2wd?

bouncytruck · 04-08-2010, 11:28 AM

I don't know what is involved in putting it in, but I say go for it!

72gmcshorty · 04-08-2010, 06:08 PM

after doing some research here it looks like it might be a little too complicated and time consuming. Going to stick with carb setup.

cparman · 04-08-2010, 08:57 PM

The motor mounts are the same as what came in your truck. I personally do not care for that engine. The ignition system is driven off of the cam, and IF, you have a problem with the Dizzy, it requires a water pump removal, and a very expensive diizzy replacement. If the engine is cheap, and you have the ability to wire it, well I guess it would be ok. Just not my cup off tea

low'n slow · 04-09-2010, 10:00 PM

I love the one in my SWB. Go for it.

capev86 · 04-11-2010, 10:35 AM

fuel injection is the way to go with crazy gas prices, and also it will automatically adjust to changes in altitude so you can go on cross country trips!

Cap'n Hook · 04-11-2010, 04:26 PM

Is the '96 vette an auto or 6 speed. If it's 6 speed, it's not an LT1, it's an LT4, 330 horse! Love the LT4's!

Firebirdjones · 04-11-2010, 05:14 PM

Funny, I did an LT1/4L60E swap in my wifes jeep. Very easy swap, hands down easier than an LS swap. Oil pan and motor mounts and exhaust are still conventional style so it doesn't complicate things.
Runs pretty decent too, 13.40's at 103 mph on 32" bfg all terrains and 6 inches of lift

Keeping the fuel injection is cake too. I used Howell Engine Management systems for mine. They supply the computer with a custom tune specifically for the application, and a custom made harness also specifically made for what you are doing. Everything is labeled. Literally plug and play. Fired right up on the first hit of the key.

Nothing really wrong with LT motor's, just have to know your way around them. You don't have to keep the opti either. There are several kits on the market to convert them several ways, even coil-per-ignition setups. If you wish for a carb, you can even switch it over to a conventional distributor if you like. All the provisions are already there, and a plug is made for the front timing cover once the opti is removed. Really makes the engine just as simple as any Gen 1 sbc.

Wouldn't know it by looking at it, a real sleeper.

**Yukon Jack** · 04-11-2010, 11:19 PM

Nice Jeep and gotta like that powerplant!

71jimmy · 04-11-2010, 11:20 PM

Sweet conversion.

Firebirdjones · 04-12-2010, 12:23 PM

Thanks, I know it's a blazer site, but I couldn't resist when questions popped up on an LT1 swap

That was a frame off job that took a while and spent way too much money. There was a ton of custom stuff I fabbed throughout the scrambler,,,,but the drivetrain conversion is straight forward and very simple.

Unlike the LS swap I'm gearing up for on our 72 blazer. That's going to be rather involved and quite honestly, I'm mentally preparing myself for it to be a pain.

JMac11 · 04-12-2010, 01:34 PM

Would love more details on the Scrambler..... mid LT1 here need inspiration

Firebirdjones · 04-12-2010, 03:50 PM

I'd probably get booted from the site talking about jeeps

I'm into everything though.

I've got a complete photo album from the build start to finish. We did a candy brandywine paint with ghost flames on the hood. Rebuilt the LT1 but it's internally stock, just .030 over. 4L60E with a dana 300 transfer case and 4.10 gears.
If you have an email I can send you pics and details that way, rather than clog up the blazer site with, dare I say it, Jeep info??

04-08-2010, 01:45 AM	#1
72gmcshorty Registered User Join Date: Jul 2001 Location: North Delta, British Columbia Posts: 1,344	Should i put lt1 into my 2wd blazer? I have a chance to buy a motor/trans out of 96 corvette. Whats involved in putting this into a 72 2wd? __________________ 1992 Gmc 2wd 1972 Chevy Blazer 2wd

04-08-2010, 11:28 AM	#2
bouncytruck SKINNY TIRES RULE! Join Date: Sep 2001 Location: Bothell, WA Posts: 11,038	Re: Should i put lt1 into my 2wd blazer? I don't know what is involved in putting it in, but I say go for it! __________________ bouncytruck 1972 K5 The Hauler 1994 K1500 Suburban The Daily2010 Kia Soul Wife's Ride2014 Fiat 500L

04-08-2010, 06:08 PM	#3
72gmcshorty Registered User Join Date: Jul 2001 Location: North Delta, British Columbia Posts: 1,344	Re: Should i put lt1 into my 2wd blazer? after doing some research here it looks like it might be a little too complicated and time consuming. Going to stick with carb setup. __________________ 1992 Gmc 2wd 1972 Chevy Blazer 2wd

04-08-2010, 08:57 PM	#4
cparman sharp as a marble Join Date: Jan 2007 Location: atlantic beach,florida Posts: 1,082	Re: Should i put lt1 into my 2wd blazer? The motor mounts are the same as what came in your truck. I personally do not care for that engine. The ignition system is driven off of the cam, and IF, you have a problem with the Dizzy, it requires a water pump removal, and a very expensive diizzy replacement. If the engine is cheap, and you have the ability to wire it, well I guess it would be ok. Just not my cup off tea

04-09-2010, 10:00 PM	#5
low'n slow Too Dumb To Know Better Join Date: Nov 2005 Location: Texas Posts: 882	Re: Should i put lt1 into my 2wd blazer? I love the one in my SWB. Go for it.

04-11-2010, 10:35 AM	#6
capev86 Registered User Join Date: May 2009 Location: Eliot, Maine Posts: 1,314	Re: Should i put lt1 into my 2wd blazer? fuel injection is the way to go with crazy gas prices, and also it will automatically adjust to changes in altitude so you can go on cross country trips!

04-11-2010, 04:26 PM	#7
Cap'n Hook Workin to live... Join Date: Jun 2003 Location: Texas Hill Country Posts: 261	Re: Should i put lt1 into my 2wd blazer? Is the '96 vette an auto or 6 speed. If it's 6 speed, it's not an LT1, it's an LT4, 330 horse! Love the LT4's! __________________ Jason

04-11-2010, 05:14 PM	#8
Firebirdjones Registered User Join Date: Oct 2009 Location: Prescott, Arizona Posts: 2,396	Re: Should i put lt1 into my 2wd blazer? Funny, I did an LT1/4L60E swap in my wifes jeep. Very easy swap, hands down easier than an LS swap. Oil pan and motor mounts and exhaust are still conventional style so it doesn't complicate things. Runs pretty decent too, 13.40's at 103 mph on 32" bfg all terrains and 6 inches of lift Keeping the fuel injection is cake too. I used Howell Engine Management systems for mine. They supply the computer with a custom tune specifically for the application, and a custom made harness also specifically made for what you are doing. Everything is labeled. Literally plug and play. Fired right up on the first hit of the key. Nothing really wrong with LT motor's, just have to know your way around them. You don't have to keep the opti either. There are several kits on the market to convert them several ways, even coil-per-ignition setups. If you wish for a carb, you can even switch it over to a conventional distributor if you like. All the provisions are already there, and a plug is made for the front timing cover once the opti is removed. Really makes the engine just as simple as any Gen 1 sbc. Wouldn't know it by looking at it, a real sleeper. Last edited by Firebirdjones; 04-11-2010 at 09:34 PM.

04-11-2010, 11:19 PM	#9
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,686	Re: Should i put lt1 into my 2wd blazer? Nice Jeep and gotta like that powerplant! __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14

04-11-2010, 11:20 PM	#10
71jimmy Registered User Join Date: Mar 2004 Location: Sacramento, CA Posts: 1,083	Re: Should i put lt1 into my 2wd blazer? Sweet conversion. __________________ '71 Jimmy, 350, SM465, NP205, 2in Tuff Country lift, 33s on rallies, TBI, softtop and hardtop "If life was fair you'd be able to afford one of each and a garage large enough to house them all."

04-12-2010, 12:23 PM	#11
Firebirdjones Registered User Join Date: Oct 2009 Location: Prescott, Arizona Posts: 2,396	Re: Should i put lt1 into my 2wd blazer? Thanks, I know it's a blazer site, but I couldn't resist when questions popped up on an LT1 swap That was a frame off job that took a while and spent way too much money. There was a ton of custom stuff I fabbed throughout the scrambler,,,,but the drivetrain conversion is straight forward and very simple. Unlike the LS swap I'm gearing up for on our 72 blazer. That's going to be rather involved and quite honestly, I'm mentally preparing myself for it to be a pain. Last edited by Firebirdjones; 04-12-2010 at 12:24 PM.

04-12-2010, 01:34 PM	#12
JMac11 Registered User Join Date: May 2005 Location: Tallahassee Fl Posts: 773	Re: Should i put lt1 into my 2wd blazer? Would love more details on the Scrambler..... mid LT1 here need inspiration

04-12-2010, 03:50 PM	#13
Firebirdjones Registered User Join Date: Oct 2009 Location: Prescott, Arizona Posts: 2,396	Re: Should i put lt1 into my 2wd blazer? I'd probably get booted from the site talking about jeeps I'm into everything though. I've got a complete photo album from the build start to finish. We did a candy brandywine paint with ghost flames on the hood. Rebuilt the LT1 but it's internally stock, just .030 over. 4L60E with a dana 300 transfer case and 4.10 gears. If you have an email I can send you pics and details that way, rather than clog up the blazer site with, dare I say it, Jeep info??



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.