|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-15-2010, 12:10 PM
|
#1 |
|
Registered User
Join Date: Apr 2009
Location: norman ok, hall park area
Posts: 8
|
control arms 64 c-10 help
i brought some new control arms and i am installing them and i was told to align the hole on the shaft with the bolt head on the cross member clamp well my old control arms had only one hole on the shaft and new ones have 2 and the ones on the new shaft are farther apart than the two clamps on the cross member so do i align the front hole on the shaft with the front on the clamp or the rear one
|
|
|
|
08-16-2010, 12:10 AM
|
#2 |
|
60-66 Nut
  Join Date: Mar 2007
Location: Coeur d'Alene, Idaho
Posts: 23,252
|
Re: control arms 64 c-10 help
Have you compared the hole placement on the new control arm shafts to the hole placement on your originals? You will want to position the new ones in the same position front to back as your originals. If this isn't possible with the new control arms, then they are not the correct ones.
__________________
Power Steering Box Adapter Plates For Sale HERE Power Brake Booster Adapter Brackets For Sale '63-'66 HERE and '67-'72 HERE and '60-'62 HERE and "60-'62 with clutch HERE Rear Disc Brake Brackets For Sale. Impala SS calipers HERE Camaro Calipers HERE D52 Calipers HERE 6 Lug HERE Hydroboost Mounting Plates HERE |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
