|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-27-2002, 01:10 PM
|
#1 |
|
WHYBYNU when old will do
Join Date: Feb 2002
Location: Hot Springs, AR.
Posts: 643
|
Gas gauge not working??
I just put the bed on my truck after a complete make-over this winter and just noticed that the gas needle goes way past full. Did i miss a wire or have a bad ground?
I havent driven the truck since last fall and the the truck is new to me ( bought it tore it apart and cleaned it up over the winter and ready to put on the road)so I dont remember if it worked or not before I tore the truck apart.. Oh yea its a 84 with 305/350 2wheel drive. ------------------
__________________
71 Cheyenne super 2 tone green and white ZZ6 - Th350 4/6 drop 20x8.5 / 20x10 Billet Specialties |
|
|
|
03-27-2002, 07:26 PM
|
#2 |
|
Registered User
 
Join Date: Feb 2000
Location: Maquoketa, Ia/ Orr, Mn
Posts: 3,051
|
I had the same problem with my '74 K/20. I bought it and had to put a new tank in it. I replaced the ground wire after I got it back on the road and the guage is now working again. Check you power wire too! That could be rubbing on the crossmember or have a bare spot, most likely the ground though. Hope this helps.
__________________
'51 South Bend Model "9A" '56 Chevy 3600 NAPCO '74 Chevy Cheyenne Super K20-restored on 37's '72 GMC Sierra Custom K2500- in progress '08 GMC Envoy Denali '12 GMC Sierra 2500HD Denali '17 GMC Yukon XL VCCA member #58596 http://www.nohrco.com |
|
|
|
|
04-02-2002, 09:43 PM
|
#3 |
|
Registered User
Join Date: Sep 2001
Location: Pittsburgh Pa Good Ole USA
Posts: 10
|
go with mjn, i had that problem twice.once when i had some one put a new flexplate in and they smash the power wire with the crossmember bolts, and twice when i drop the tank, put it back in and didn't have a good ground.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
