Anyone running this set up - The 1947 - Present Chevrolet & GMC Truck Message Board Network

thebabybrahma · 03-19-2011, 03:24 PM

3" drop spindles with 2"shackles in the rear riding on 18s up front and 20s out back??

i put the spindles on no problem, but when we installed the 5" flip in the rear - the drive shaft slid too far up in the tranny and also rubbed a center carrier bearing support, just too low for me.
may end up with a 3 to 4 " shackle in the rear and run 18s all around.

Front fenderwells are 28.75" high and the rear is 30.5" as is sits now
Just thought the 2" rake on the truck now might look good with the 18/20 combo.
thanks guys

thebabybrahma · 03-19-2011, 03:40 PM

dropped a pic for the Photo magicians to work on. thanks

03-19-2011, 03:24 PM	#1
thebabybrahma Registered User Join Date: Sep 2007 Location: Gray,Tennessee Posts: 182	Anyone running this set up 3" drop spindles with 2"shackles in the rear riding on 18s up front and 20s out back?? i put the spindles on no problem, but when we installed the 5" flip in the rear - the drive shaft slid too far up in the tranny and also rubbed a center carrier bearing support, just too low for me. may end up with a 3 to 4 " shackle in the rear and run 18s all around. Front fenderwells are 28.75" high and the rear is 30.5" as is sits now Just thought the 2" rake on the truck now might look good with the 18/20 combo. thanks guys __________________ '85 C-10, with 93 LT-1 & 4L60 1985 GMC, lookin' for its big block motor - SOLD '72 Chevy C-10 Cheyenne-SOLD Last edited by thebabybrahma; 03-19-2011 at 03:41 PM. Reason: add more info

03-19-2011, 03:40 PM	#2
thebabybrahma Registered User Join Date: Sep 2007 Location: Gray,Tennessee Posts: 182	Re: Anyone running this set up dropped a pic for the Photo magicians to work on. thanks __________________ '85 C-10, with 93 LT-1 & 4L60 1985 GMC, lookin' for its big block motor - SOLD '72 Chevy C-10 Cheyenne-SOLD



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.