|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-17-2011, 12:22 AM
|
#1 |
|
Registered User
Join Date: May 2011
Location: Thibodaux, LA
Posts: 114
|
Replacing turn signal stalk/cruise switch
Ok, well, I'm trying to swap out my turn signal stalk/cruise control switch with the one I yanked out of an '83 'burb in the junkyard.. It was easy to remove, just disconnected the wires and a slight tug had them out of the column. Now I'm trying to put this on my '86.. Is there any way to run this wire down the column without tearing the column apart??
Posted via Mobile Device Posted via Mobile Device
__________________
Jay Bernard, Thibodaux, LA 1986 SWB Sierra Classic Stock roller 350/700R4 2008 Buick Enclave CXL 3.6 VVT, 6spd auto. PAINFULLY stock... (wife's ride) |
|
|
|
06-17-2011, 02:25 AM
|
#2 |
|
Parts and more parts
Join Date: Nov 2003
Location: Lebo, Kansas (middle of nowhere
Posts: 6,821
|
Re: Replacing turn signal stalk/cruise switch
Yes. You can do it with a stiff small gauge wire and some patience. I have a piece that I took out of a spring set on an old bench seat and it works quite well for things like this. The wire is pretty rigid.
__________________
Frank |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
