|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-17-2012, 09:43 PM
|
#1 |
|
Registered User
Join Date: May 2007
Location: East Haven, CT
Posts: 882
|
OEM length rear shocks with extenders?
Flip kit in rear with 1'' lowering shackles and c-notch. Front consists of 2.5 spindles and 2'' Belltech springs.
Doetsch-Tech shocks all around. Front is harsh over bumpy roads and the back is extremely bouncy. I recently added Western Chassis shock extenders in hopes of a better ride out back. If anything, it made the ride even bouncier! Is it possible to run oem-length shocks with the extenders with my setup? I'm thinking any of these "drop shocks" are just too rough for what I'm looking for. I know it's a truck and I know it's lowered, but there has to be a better ride than this? I already found a vendor who sells KYB GR-2 for the front lowered 2''.
__________________
87 Chevy 2wd SWB: 305/700r4 Dual Exhaust, K&N Filter, Injector Pod Spacer, TBI Spacer, Belltech Front Sway Bar, Corvette Servo, Western Chassis 4/6 and c-notch |
|
|
|
01-17-2012, 10:22 PM
|
#2 |
|
Registered User
Join Date: Dec 2007
Location: Palmer, Alaska
Posts: 13,821
|
Re: OEM length rear shocks with extenders?
That is one of the reasons to use the extenders, the ability to use stock shocks.
The other reason is that it helps shock angle. Posted via Mobile Device
__________________
 CHEVY ONLY
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
