|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-05-2012, 01:14 PM
|
#1 |
|
Chevy Only Tx
Join Date: May 2009
Location: Pecos,Tx
Posts: 1,061
|
Dropmember motor mount/headers Q...
I traded my full length headers for some block hugger headers due to my flanges hitting the ground when aired out. Now that my truck is completely apart I'm curious if those block hugger headers will clear my motor mounts. They are the Speedway Motors plain like in the pic below. Anyone have feed back for me? Just curious if my bend on my exhaust will be hitting the mounts or even be too much of a bend to clear any other obsticales.
 Posted via Mobile Device
__________________
Chevy Only Tx......... |
|
|
|
07-05-2012, 02:06 PM
|
#2 |
|
Senior Member
Join Date: Dec 2003
Location: Mesa,Az
Posts: 3,981
|
Re: Dropmember motor mount/headers Q...
Shouldn't be a problem. Dino has ran that style header on a couple of his Dropmembered trucks.
Nate
__________________
www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003! |
|
|
|
|
07-06-2012, 01:33 AM
|
#3 |
|
Registered User
Join Date: Jan 2009
Location: Louisville,Ky
Posts: 5,811
|
Re: Dropmember motor mount/headers Q...
Just hit up dinos63 im sure he can tell you the brand header he used and take some pictures for you of his exhaust set up.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
