Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
09-07-2012, 05:28 PM | #1 |
Registered User
Join Date: Jul 2007
Location: Ontario Canada
Posts: 1,006
|
Installed MSD now problems
Going to the track tomorrow so I thought I would install my MSD 6AL box..install went good ,fired right up . I then tried the 3000 chip to see how it worked and revved it up and like it supposed to it would not go past 3 grand but also it backfired once , So I put my 6000 chip in and took it for a ride. Now when i hammer the throttle from a stop it stalls , never had that problem before , it used to just leave hard. Could it be possible the accel pump on my Holley blew from the backfire or does everything have to be retuned again ?
__________________
1985 C10 2004 Avalanche |
09-07-2012, 07:43 PM | #2 |
Registered User
Join Date: Jun 2010
Location: Columbus, Oh
Posts: 152
|
Re: Installed MSD now problems
Power valve blown?
Timing OK? |
09-07-2012, 08:06 PM | #3 |
Registered User
Join Date: Jul 2007
Location: Ontario Canada
Posts: 1,006
|
Re: Installed MSD now problems
Got her fixed...my own stupidity !!!!!!!
__________________
1985 C10 2004 Avalanche |
09-10-2012, 04:09 AM | #4 |
Registered User
Join Date: Aug 2009
Location: PA
Posts: 883
|
Re: Installed MSD now problems
|
09-10-2012, 05:07 PM | #5 |
Registered User
Join Date: Jul 2007
Location: Ontario Canada
Posts: 1,006
|
Re: Installed MSD now problems
Well the last time i had it out I run it a little lower on fuel then usual so when i took it for a test run after the install it acted up like this , later I took it to put some gas in it and i ended up running out . After putting gas in it ran fine again...lol...how embarrassing .
__________________
1985 C10 2004 Avalanche |
09-15-2012, 04:42 AM | #6 | |
Registered User
Join Date: Aug 2009
Location: PA
Posts: 883
|
Re: Installed MSD now problems
Quote:
engine would just crank and crank and crank and crank. nothing. we checked everything. and by everything, i mean every single piece that has to do with starting the engine. turns out it was bad gas -__- turns out my engine doesnt like anything but fresh gas. |
|
09-10-2012, 09:55 PM | #7 |
Registered User
Join Date: Oct 2005
Location: Orygun
Posts: 169
|
Re: Installed MSD now problems
Oh so MSD has no relation to D'OH!
Amazing how it's almost NEVER the part but the part installer. I know cuz I've installed parts, sometimes w/ more than a BFH.
__________________
http://www.cardomain.com/id/Schralper |
Bookmarks |
|
|