Track Bar Problems

[Goinlow64]

Hey Guys, I have a slight issue going on with my track bar. The truck is a 64, but the rear end has been switched by the PO to a 65 or later. I put 4" coil springs in the rear and might do 1" lowering blocks in the futre.

Here is the problem, the track bar is not straight from the frame mount to the mount on the axle. Should I relotate the fram mount? I have attached a couple pictures for you guys to see. The track bar I have is a 24" adjustable from CPP.

In the pics, you can see the angle of the bar is off by a couple of inches. Was the 65 and later frame mount in a different spot than the 64?

Thanks!