steering arm install help lol - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mike britchzz · 03-23-2013, 07:48 PM

i have a 87 3/4 i actually got the arm off quite easy to with a ball point hammer

any ways i got new nuts and cone washers. how do u get them to get flush with the new sterring arm for the lift. or do they stick out like mine about 1/4 inch or so. there tight but truck is on a jack stand so dont wanna yank too too hard. any help would be great thanks

LONGHAIR · 03-23-2013, 08:30 PM

They may stick up a little. It depends upon how deep the tapered holes were drilled in the new arm. I have seen them like that, though a 1/4" sounds excessive...

mike britchzz · 03-23-2013, 09:32 PM

Quote:

Originally Posted by LONGHAIR

They may stick up a little. It depends upon how deep the tapered holes were drilled in the new arm. I have seen them like that, though a 1/4" sounds excessive...

I dunno what brand arm it is. Bought the parts used. Will try to get them down further
Posted via Mobile Device

03-23-2013, 07:48 PM	#1
mike britchzz Registered User Join Date: Dec 2012 Location: winchester, va Posts: 17	steering arm install help lol i have a 87 3/4 i actually got the arm off quite easy to with a ball point hammer any ways i got new nuts and cone washers. how do u get them to get flush with the new sterring arm for the lift. or do they stick out like mine about 1/4 inch or so. there tight but truck is on a jack stand so dont wanna yank too too hard. any help would be great thanks



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.