|
08-09-2013, 04:50 AM
|
#1 |
|
Registered User
Join Date: Jun 2013
Location: harviell, mo
Posts: 246
|
trans hump size?
can someone tell me if this is the high hump or low hump tunnel or if photo not good enough tell me how to tell diff. truck was orginally a column shift bit PO changed to 350th floor shift. need to figure out for rubber floor mat im looking at buying from stock interiors.
Posted via Mobile Device
__________________
live like you are dying 
|
|
|
|
08-09-2013, 05:43 AM
|
#2 |
|
Registered User
Join Date: Aug 2012
Location: Rathdrum ID
Posts: 1,129
|
Re: trans hump size?
That is a low hump. I have a high I just found out.
__________________
66 shorty 
|
|
|
|
|
08-09-2013, 09:03 AM
|
#3 |
|
Registered User
Join Date: Jan 2013
Location: Imperial, MO
Posts: 1,003
|
Re: trans hump size?
Agreed. That's definitely a low hump.
|
|
|
|
|
08-09-2013, 10:13 AM
|
#4 |
|
Senior Enthusiast
Join Date: Feb 2007
Location: Spokane Valley, WA
Posts: 8,356
|
Re: trans hump size?
For comparison, this is what a high hump looks like:
__________________
My Build Thread: http://67-72chevytrucks.com/vboard/s...d.php?t=444502 |
|
|
|
|
08-09-2013, 01:17 PM
|
#5 |
|
Registered User
Join Date: Jun 2013
Location: harviell, mo
Posts: 246
|
Re: trans hump size?
thanks everyone....
thanks markeb01 for the photo to compare to.. Posted via Mobile Device
__________________
live like you are dying
|
|
|
|
|
08-09-2013, 01:21 PM
|
#6 |
|
Registered User
Join Date: Jun 2013
Location: harviell, mo
Posts: 246
|
Re: trans hump size?
as you can see in my photo my floors are a little rusty (surface) and dirty as heck. what would be the best way to clean them up so i can put primer or bedliner material on it. i dont have a dande blaster so that is out...
Posted via Mobile Device
__________________
live like you are dying
|
|
|
|
|
08-09-2013, 01:48 PM
|
#7 |
|
meowMEOWmeowMEOW
Join Date: Sep 2009
Location: MKE WI
Posts: 7,128
|
Re: trans hump size?
big 90* wire wheel and good protective equipment (it WILL chuck little wires at high speed at your face.) It'll take everything off without damaging the metal, be careful around areas with dried seam sealer etc, they create a good amount of debris with the wheel hits them. If the rust is into the metal at all, hit it with some POR 15 before you put a bedliner on it.
__________________
'66 Short Step / SD Tuned / Big Cam LQ4 / Backhalfed /Built 4l80e / #REBUILDEVERYTHING  |
|
|
|
 |
| Bookmarks |
|
|
\\ MY YOUTUBE CHANNEL
Linear Mode
