Aftermarket A/C with an ls swap.

[Operatorfailure]

I'm sure all of the aftermarket kits will work with an ls swap, but are there any that come with a compressor and mouting brackets for the ls setup? I have my compressor from the pullout, but my motor mounts get in the way and I didn't do the mod to the plates to get them to fit when I put the engine in so I think that is out of the question now. So, does anyone know if any brand offers what I'm needing or if I need to buy the sanden compressor and top mount from one of the available companies, plus the full kit?

[Clyde65]

You may need a high mount AC mount, Kwik Performance and some others off them, With KwikPerformance you would need a Sanden compressor with the appropriate drive. If your going to order from an ac vendor, then just ask for the serpentine belt pulley.

I have seen some with the ability to use an A4 compressor in the high mount config but I am not sure what brand of mounts they are.

Good luck!

[Operatorfailure]

Thanks for the info, I was hoping someone would offer the whole kit with the ls mounts but I guess I can piece it together.
Posted via Mobile Device

[Edge64]

Check out Old Air Products. That's who I used and they offer the entire setup
for ls high mount compressor.

[Operatorfailure]

Originally Posted by Edge64

Check out Old Air Products. That's who I used and they offer the entire setup
for ls high mount compressor.

Awesome. That's exactly what I wanted to hear!

Thanks.
Posted via Mobile Device

[chevydog66]

I bought the Dirty Dingo bracket and then a Sanden comp off Ebay. Just had to purchase a new belt to run everything.