Transmission question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Hugh Mongus · 02-06-2014, 02:50 PM

I was going to change the fluid and filter in my TH350 a couple of nights ago, but noticed that I cannot get the two back bolts out of the pan. The cross member is in the way. I thought about removing the cross member but there are two bolts on each side of the frame that would require lifting the cab to get them out. My truck also has a new drive shaft from the PO.

My question is, what transmission do you think would have came with it originally? I am assuming the ability to remove the transmission pan without removing the cross member would have been possible with the original configuration.

02-06-2014, 02:50 PM	#1
Hugh Mongus Registered User Join Date: Jan 2014 Location: Tulsa, OK Posts: 360	Transmission question I was going to change the fluid and filter in my TH350 a couple of nights ago, but noticed that I cannot get the two back bolts out of the pan. The cross member is in the way. I thought about removing the cross member but there are two bolts on each side of the frame that would require lifting the cab to get them out. My truck also has a new drive shaft from the PO. My question is, what transmission do you think would have came with it originally? I am assuming the ability to remove the transmission pan without removing the cross member would have been possible with the original configuration.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.