tranny tunnel question? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mark 66 · 02-16-2014, 05:24 PM

My sons truck previous owner hacked the tunnel all up to install floor shift. I found a good donor piece.I cut the sections so each would overlap in factory seam.question is would it be better to weld it in or bolt it?

HumphreyMurdoch · 02-16-2014, 06:58 PM

If you make it look nice and structurally strong, I'd say bolt it in. The floor in my '62 is bolted in and made pulling the trans so much easier.

02-16-2014, 05:24 PM	#1
mark 66 Registered User Join Date: Jun 2012 Location: cleawater florida Posts: 246	tranny tunnel question? My sons truck previous owner hacked the tunnel all up to install floor shift. I found a good donor piece.I cut the sections so each would overlap in factory seam.question is would it be better to weld it in or bolt it?

02-16-2014, 06:58 PM	#2
HumphreyMurdoch Registered User Join Date: May 2012 Location: Murphy, MO Posts: 172	Re: tranny tunnel question? If you make it look nice and structurally strong, I'd say bolt it in. The floor in my '62 is bolted in and made pulling the trans so much easier.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.