|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-22-2014, 12:27 PM
|
#1 |
|
Registered User
 
Join Date: Feb 2014
Location: Portland, Oregon
Posts: 18
|
1970 blazer 350 Distributor swap.
I have a 1970 blazer and am beginning to change a few things. I got a great deal on an almost new Accel HEI replacement distributor with a super coil mounted on top of the cap. It's the larger diameter HEI GM version. Now that I am looking at the engine I am wondering if there is enough clearance for it? Anyone able to get one installed without altering the firewall?
|
|
|
|
03-22-2014, 01:52 PM
|
#2 |
|
Senior Member
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,768
|
Re: 1970 blazer 350 Distributor swap.
I had one in mine for awhile, had just enough room to get my fingers between the distr. and firewall...
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
|
03-22-2014, 09:17 PM
|
#3 |
|
Registered User
Join Date: Jan 2001
Location: Orem, Utah
Posts: 7,985
|
Re: 1970 blazer 350 Distributor swap.
I have a GM HEI in mine. It's tight, but it fits.
When I first put it in, there was a body bolt (pointed end) coming through the firewall that shorted one of my wires. Once I rerouted the wires, I didn't have any problems. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
