6L80E LS3 Swap in 65 C10? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Dubnova · 03-24-2014, 07:31 PM

Can anybody tell me if it's possible to swap a LS3 with a six speed 6L80e trans into 65 C10 without cutting up the floor pan with a low hump?

**First c10** · 03-24-2014, 08:47 PM

In my 70 wth a low hump I had to stretch it. By pushing up on the center of the hump with a big pipe and floor jack, and then used a dead blow hammer to bump the sides in to make a hump with a curve. I gained about 1" pretty fast and also bent the flange lip up.

03-24-2014, 07:31 PM	#1
Dubnova Registered User Join Date: May 2012 Location: Madison Alabama Posts: 201	6L80E LS3 Swap in 65 C10? Can anybody tell me if it's possible to swap a LS3 with a six speed 6L80e trans into 65 C10 without cutting up the floor pan with a low hump? Last edited by Dubnova; 03-24-2014 at 07:37 PM.

03-24-2014, 08:47 PM	#2
First c10 Registered User Join Date: Dec 2012 Location: Los Banos CA Posts: 2,705	Re: 6L80E LS3 Swap in 65 C10? In my 70 wth a low hump I had to stretch it. By pushing up on the center of the hump with a big pipe and floor jack, and then used a dead blow hammer to bump the sides in to make a hump with a curve. I gained about 1" pretty fast and also bent the flange lip up. __________________ 1956 Chevy Bel Air 2 door 1956 Chevy 210 4 Door 1970 K20 LWB project the Hulk build w/Supercharged 4.8L-ly2/4L60E HULK BUILD 1970 C10 Yellow/White Deluxe LWB w/ 5.3L-LC9/6L80E 1968 K10 LWB Dark green my son calls it "THE HULK Jr"HULK JR SOLD GO GO!!!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.