|
05-02-2014, 06:43 PM
|
#1 |
|
Account Suspended
Join Date: Jan 2009
Location: Kuna, Idaho
Posts: 1,046
|
Is there a way
Wondering if there is a way to take out the tail light buckets from inside the bed without cutting up the bed itself. Is it possible or not?
|
|
|
|
05-02-2014, 07:00 PM
|
#2 |
|
Senior Member
 
Join Date: Oct 2010
Location: Cadiz, Ky
Posts: 514
|
Re: Is there a way
Not sure I understand the question. The tail light buckets come out on the outside.
__________________
1972 Chevy LWB Roadster 1999 Chevy Silverado 2wd 2015 Chevy High Country 4x4 Crew Cab |
|
|
|
|
05-02-2014, 07:46 PM
|
#3 |
|
Lurky lurky
Join Date: Sep 2005
Location: Maryville, TN
Posts: 553
|
Re: Is there a way
I did it less than a week ago and just took the two screws out of the plate and pulled them through the cut out in the bed side. It was a tight fit but tape on the bodywork and a little prying with a pocket screwdriver and they were out.
|
|
|
|
|
05-02-2014, 10:17 PM
|
#4 | ||
|
Account Suspended
Join Date: Jan 2009
Location: Kuna, Idaho
Posts: 1,046
|
Re: Is there a way
Quote:
Quote:
|
||
|
|
|
|
05-03-2014, 12:30 AM
|
#5 |
|
Lurky lurky
Join Date: Sep 2005
Location: Maryville, TN
Posts: 553
|
Re: Is there a way
I should be able to post pics early next week if you don't get it before then. It's all apart right now.
|
|
|
|
|
05-03-2014, 05:09 PM
|
#6 | |
|
Account Suspended
Join Date: Jan 2009
Location: Kuna, Idaho
Posts: 1,046
|
Re: Is there a way
Quote:
|
|
|
|
|
|
05-03-2014, 05:19 PM
|
#7 |
|
Registered User
Join Date: Apr 2014
Location: calgary alberta
Posts: 1,248
|
Re: Is there a way
Ya the buckets come out there just screwed in undo the screws and they pop right out
|
|
|
|
|
05-03-2014, 05:22 PM
|
#8 |
|
Registered User
Join Date: Apr 2014
Location: calgary alberta
Posts: 1,248
|
Re: Is there a way
I took mine out so I could weld over the chrome strip holes so I didn't have to have the chrome around the lights
|
|
|
|
|
05-10-2014, 08:21 PM
|
#9 | |
|
Lurky lurky
Join Date: Sep 2005
Location: Maryville, TN
Posts: 553
|
Re: Is there a way
Quote:
Take out the two screws in the housing out, then I gently pried on the bottom and pulled it out at an angle.  Then I had enough room to get my fingers under the bottom of it  It comes out, just barely in the cut out for it  Then I unplugged the wiring to the bulb.  End result.  Hope that clears it up for you... |
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
