|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-01-2014, 12:46 PM
|
#1 |
|
Registered User
Join Date: Oct 2006
Location: Austin, TX
Posts: 100
|
Front Spindle - Damaged?
I'm doing a brake job on all four drums... new shoes, cylinders, and hardware (springs, clips, etc) and I'm hoping y'all might have some of advice on this spindle. Is that just rust that I can clean off or is that evidence of heat damage and/or wear?
I've done enough brake jobs to feel comfortable with it but I've never had to mess with spindles before. 
|
|
|
|
12-01-2014, 01:32 PM
|
#2 |
|
Senior Member
 
Join Date: Jan 2011
Location: Hayes Va
Posts: 4,569
|
Re: Front Spindle - Damaged?
I assume you are talking about the rough looking area in the middle. That is the raw area of the casting that did not get machined when the made the spindle. It is not a problem at all.
Jimmy
__________________
60 to 66 Chevy and GMC window decals http://67-72chevytrucks.com/vboard/s...d.php?t=661131 Good friends, good food and a hotrod what else do you need? 1966 BBW long fleet Daily driver 1965 BBW short fleet Sold and going to a good home 1965 Suburban 2003 3500 Duramax 2005 Ultra Classic |
|
|
|
|
12-01-2014, 02:10 PM
|
#3 |
|
Registered User
Join Date: Oct 2006
Location: Austin, TX
Posts: 100
|
Re: Front Spindle - Damaged?
Yep, I was talking about the rusty looking area. I was looking at new spindles online and none of them had rough areas like that... they were all smooth and shiny.
I'm glad to hear it's not an issue though as I really just want to get the brakes back on and rolling again. Thanks! |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
