|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-18-2015, 04:25 PM
|
#1 |
|
Registered User
Join Date: Jun 2014
Location: Austin, MN
Posts: 15
|
How to extend inside door handle shaft/sprig?
So I thought I was being clever with my custom door panels, and they turned out nice. BUT, they are thicker than the stock cardboard. Close to 1/2 inch thick. Problem is there isn't enough shaft poking through for the door handle to grab on to. I need a good 3/8 to 1/2 inch. It looks like I need another head welded onto the existing one. That doesn't even look possible. Does anyone have any ideas? I'm kinda at a loss here.
Thanks Brandon from MN |
|
|
|
02-18-2015, 04:32 PM
|
#2 |
|
Registered User
Join Date: Jun 2014
Location: Austin, MN
Posts: 15
|
Re: How to extend inside door handle shaft/sprig?
Oh, and BTW, I've thought about "poppers" but I really like handles. That would be worst case scenario for me.
|
|
|
|
|
02-18-2015, 06:57 PM
|
#3 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: How to extend inside door handle shaft/sprig?
I have never searched for them, but would think someone along the way thought to make extender with female spline and set screw on one end and spline for handle on the other. I know they make them for shower handles when you add tile....
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
|
|
|
|
02-18-2015, 08:30 PM
|
#4 |
|
Registered User
Join Date: Jan 2015
Location: Santa Monica
Posts: 264
|
Re: How to extend inside door handle shaft/sprig?
Would affect window cranks too... unless you went electric
You might be able to remove the internal release mech, cut and weld (perhaps even solder) the shaft back using a collar to extend and align it. Just a thought...
__________________
Déjà vu. It's that feeling you get when you hit your thumb with the hammer a second time '59 Chevy 3100 Stepside |
|
|
|
|
02-18-2015, 10:15 PM
|
#5 |
|
Registered User
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,711
|
Re: How to extend inside door handle shaft/sprig?
I thought that at one time someone sold extensions that would fit them but I don't know how far they would reach, I think they were for Vans back in the custom van days. Some might fit older pickup shafts though.
__________________
Founding member of the too many projects, too little time and money club. My ongoing truck projects: 48 Chev 3100 that will run a 292 Six. 71 GMC 2500 that is getting a Cad 500 transplant. 77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
