Driveline/Joint Help Needed - The 1947 - Present Chevrolet & GMC Truck Message Board Network

SunSoaked · 05-29-2015, 09:59 AM

Here's my setup:
69K10- Swapped in a Dana 60 up front and a NP205 T-case. Now I'm trying to piece together the axle to connect the two. The truck has a 2 inch lift.

Currently I have a yoke (32 spline) output that I can use on the front or rear of the t-case.

Looking online I see I can use a flange (flat face) or Yoke (rabbit ears?) style. I don't know what came of the truck or which style I should use. It appears the Double Cardan Joint is a better way (lower angles (Constant Velocity)=less vibration?).

This is foreign to me. Any help would be appreciated.

05-29-2015, 09:59 AM	#1
SunSoaked Registered User Join Date: Dec 2011 Location: Yuma Arizona Posts: 1,525	Driveline/Joint Help Needed Here's my setup: 69K10- Swapped in a Dana 60 up front and a NP205 T-case. Now I'm trying to piece together the axle to connect the two. The truck has a 2 inch lift. Currently I have a yoke (32 spline) output that I can use on the front or rear of the t-case. Looking online I see I can use a flange (flat face) or Yoke (rabbit ears?) style. I don't know what came of the truck or which style I should use. It appears the Double Cardan Joint is a better way (lower angles (Constant Velocity)=less vibration?). This is foreign to me. Any help would be appreciated.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.