|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-22-2015, 11:15 PM
|
#1 |
|
Registered User
 Join Date: Jul 2014
Location: Madison, AL
Posts: 52
|
Wheel/Control Arm Clearance Question
Are there any known clearance issues using:
cpp 2" drop spindles stock control arms Disc brake conversion with 15" wheels 1.5" or 2" drop coil springs Wanting to use stock steel wheels if possible, knowing I may have to change to the later 5 lug wheel for brake clearance. Especially want to rule out any clearance problems with this set-up before proceeding with stock control arm paint and rebuild. |
|
|
|
11-23-2015, 10:40 PM
|
#2 |
|
Registered User
Join Date: Mar 2015
Location: Windsor,Ontario Canada
Posts: 255
|
Re: Wheel/Control Arm Clearance Question
I ran a set of the 2.5" drop spindles on stock 15" 1965 wheels but had to run spacers to clear the cast Calipers....
|
|
|
|
|
11-23-2015, 11:45 PM
|
#3 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,066
|
Re: Wheel/Control Arm Clearance Question
It depends on the 15" wheels backspacing.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
