1971 K10 lsx motor mount help

[7beast]

Hey fellas I need some advice, I have a 1971 k10 half ton that is equipped with a sbc350 th400 transmission and NP205.. i plan to keep all the drivetrain the same except for the sbc350. I plan on putting in a 5.3 motor and I was looking for advice on which motor mounts/perches fit best. Thanks in advance fellas

__________________

[57taskforce]

I will move this to ls swaps, you’re likely to get more responses there.

[mongocanfly]

What you'll need is a set of adapters that locate the rear of the LS in the same spot as the sbc..
I used Ebay adapters on mine....worked perfectly...
Mine look like pic down below

but I see alot of people using the slider style..like dirty dingo

[7beast]

Originally Posted by mongocanfly

What you'll need is a set of adapters that locate the rear of the LS in the same spot as the sbc..
I used Ebay adapters on mine....worked perfectly...
Mine look like pic down below

but I see alot of people using the slider style..like dirty dingo

Cool, and then you just used your oem mounts and oem pedestals? Is your truck a k10?

[mongocanfly]

mines a C30..but its the same...plates bolt to LS engine, sbc side bolts to plate...stock engine mounts...dropped right in, you could put the long bolts in with 2 fingers..
the slider style will give you a little room for error, so you might want to look into those..
heres a slider mount

[57taskforce]

You need an ls swap crossmember for the 67-72 4x4 trucks.
This is just one of several options

http://pacificfabrication.com/63-72-...ssmembers.html

[mongocanfly]

Didnt know you had to change the crossmember ..what issues do the stock one create?..oil pan clearance?

[57taskforce]

Yes sir, the pan doesn’t clear. I’ve read some people have had luck actually using the $50ish 55-59 v8 swap crossmember. I think I’m going to try that when I do my 6.0. It’s a hell of a lot cheaper.

[7beast]

Thanks alot for all the replies and help fellas. 57taskforce im really curious about the 55-59 chevy truck crossmember.. is there anyone else on here that can shed some light on this crossmember used on 67-72 k10?

[Acregger]

I used the engine crossmember but I got mine from Jegs-someone here posted a link before. It worked for me. The only thing I noticed is that my engine seems to sit a little higher then the other crossmember kits. I have clearance every where but it is close to the fire wall but does not hit.

[57taskforce]

http://67-72chevytrucks.com/vboard/s...=661982&page=4

Toward the end of this thread is where you find the 55-59 crossmember