|
08-21-2021, 04:11 PM
|
#1 |
|
Registered User
Join Date: Mar 2008
Location: Lawndale, NC
Posts: 658
|
5.3 to th400
I just want to be clear in the order I need to put things so this install goes off without a hitch. I have the torque converter snout spacer, the crankshaft spacer, and the aftermarket dished flexplate. The reason I'm asking is that I've seen installs where all that was needed was the snout spacer and flexplate, and others where the crank spacer had to be there too. Ill be doing this alone, so I'd really rather not put the motor in set up wrong and have to pull it back out.
__________________
1978 Scottsdale - celebrating 10 years of teaching me profanity 1990 Silverado - bought in Nov. 2016 and it's already catching up - Sold 1987 k5 blazer - sold... :\ seed money for the 81 1981 k20 4x4 - 5.3 swap in progress Events attended: Spring GOG 2011 Dale JR car show Summer 2012 Gathering at Tommys pickup parts |
|
|
|
08-21-2021, 04:56 PM
|
#2 |
|
Registered User
Join Date: Jun 2015
Location: Carlos MN
Posts: 2,132
|
Re: 5.3 to th400
I would ask the same question over on LS1tech.com.
|
|
|
|
|
08-21-2021, 06:59 PM
|
#3 |
|
Registered User
Join Date: Nov 2011
Location: Idaho
Posts: 857
|
Re: 5.3 to th400
Saw a video on the tube think it was bad luck garage had a good one and went over this.
|
|
|
|
|
08-25-2021, 08:06 AM
|
#4 |
|
Registered User
Join Date: Jan 2019
Location: Bonner Springs, KS
Posts: 56
|
Re: 5.3 to th400
I used just the snout spacer and the dished flex plate. No problems. No need for crank spacer
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
