04-04-2022, 11:47 PM | #1 |
Registered User
Join Date: Feb 2022
Location: El Paso Texas
Posts: 3
|
65 C-10 lowering.
First let me start by saying I bought my 65 about 2 years ago and this website has been a god send. You guys are some of the most helpful people ive ever met and thats no joke. Now let me move to my question. I (hopefully) attached a pic of my front passenger side suspension setup. 3" lowering springs and 2" drop spindles with brand new ball joints. Currently on stock 15s off a 64. Its sitting really close to the ground and it doesnt look right to me. Please be nice, ive never done anything like this before and figured why not start with this truck.
|
04-04-2022, 11:51 PM | #2 |
Registered User
Join Date: Feb 2022
Location: El Paso Texas
Posts: 3
|
Re: 65 C-10 lowering.
ok fixed it. This is my front suspension right now. Thoughts? What did i screw up?
|
04-04-2022, 11:58 PM | #3 |
Registered User
Join Date: Feb 2012
Location: Beautiful BC, Canada, eh?!
Posts: 2,267
|
Re: 65 C-10 lowering.
3" spindles place the control arm LOWER than the rim, so if you have a flat, you will skid to a halt on the ground.
Perfectly normal. Carry on. I have 3" spindles and cut 1-ton springs in my '77, and the control arms are 3.25" off the ground.
__________________
1961 Apache: "Grabber Orange" Shortboxed, pancake, step-notch, air-ride, turbo, LS 1977 Silverado: Shortboxed & dropped, potato-potato V8 Pontiac Firefly (Chevy Sprint): The ultimate engine swap: 5.7L in a 1.0L bag Lotus Super 7 Replica: Scratch-built street-legal rollerskate Last edited by SkinnyG; 04-05-2022 at 12:03 AM. |
04-06-2022, 06:04 PM | #4 |
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,066
|
Re: 65 C-10 lowering.
Welcome to the site.
Are you sure the spindles are 2" drop? What brand or what part number did you use? Most 'C10' era drop spindles are 2.5" or 3" although there are other possibilities. A 2.5" spindle w/a coil cut usually is about the max one can go w/o constant worry of damage to the control arms. Raising the crossmember or getting an aftermarket set-up that's raised helps gain some of that precious clearance back while being low. As for being a new builder.... Everyone had to start from nothing. The smart ones asked questions to get better results while soaking up the knowledge. Don't sweat it!
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
Bookmarks |
|
|