|
02-05-2023, 09:38 AM
|
#1 |
|
Senior Member
 
Join Date: Oct 2012
Location: mountain view arkansas
Posts: 1,316
|
230 or 350
I have a 66 c10 I am wanting to restore. I want to leave the 3 speed in it and have a 230 and a 350. Which engine should I use? I will sell the truck after I get it done but will drive and enjoy it some before that.
__________________
http://67-72chevytrucks.com/vboard/s...d.php?t=548705 |
|
|
|
02-05-2023, 10:13 AM
|
#2 |
|
Senior Member
Join Date: Mar 2015
Location: washington
Posts: 2,296
|
Re: 230 or 350
In the aggregate the truck will be worth more, when you resell it, with the 350 in it.
If the motor will be rebuilt, the cost for rebuilding each motor will be close to the same if there is a difference the 350 will be slightly less money. I wouldn't worry about the transmission, three on the tree, holding up. They are tough enough for a 350 with a reasonable driver. |
|
|
|
|
02-06-2023, 10:52 AM
|
#3 | |
|
Senior Member
Join Date: Oct 2012
Location: mountain view arkansas
Posts: 1,316
|
Quote:
|
|
|
|
|
|
02-06-2023, 10:53 AM
|
#4 |
|
Senior Member
Join Date: Oct 2012
Location: mountain view arkansas
Posts: 1,316
|
Re: 230 or 350
I am going to pull the head of the 6 and see it’s condition then make up my mind
Posted via Mobile Device |
|
|
|
|
02-06-2023, 12:43 PM
|
#5 | |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,066
|
Re: 230 or 350
Quote:
Yes, they can & do work fine under light load/acceleration. But, in my experience if there's enough traction & you mat the gas pedal, some 3spds will not be up to the task of surviving the resulting load. In my scenarios, two suffered catastrophic failures taking the internal gears, clutch set-up, & bellhousing along for the carnage ride. Both of these failures occurred when accelerating while rolling & not after dumping the clutch.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
|
02-07-2023, 08:34 PM
|
#6 |
|
Registered User
Join Date: Feb 2013
Location: central California
Posts: 2,776
|
Re: 230 or 350
A light duty driveshsft/ carrier bearing set up is easy to break with a 350 too
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
