Could anyone with an inline 6 help? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Backpayne** · 05-28-2023, 06:33 PM

Would anyone with a '63-'66 Chevy/GMC truck and an inline 6 take some measurements for me? I am installing a 292 in a '66 GMC with aftermarket frame/engine mounts and want to get it in roughly the factory placement, but the factory crossmember is gone. Even just sharing pictures would help a lot.

1. Distance from front of block to frame cross braces that the radiator sits on.

2. Distances from left and right frame to center of crank snout/harmonic balancer.

3. What degree should the engine be leaning back?

These will greatly help me install my 292.

Thanks!

**SOON2BLAZE** · 05-29-2023, 12:09 PM

I'll grab some measurements this afternoon and PM you.

**Backpayne** · 05-29-2023, 12:27 PM

Quote:

Originally Posted by SOON2BLAZE

I'll grab some measurements this afternoon and PM you.

Aw man. Thank you so much! It will be much appreciated!

05-28-2023, 06:33 PM	#1
Backpayne Senior Member Join Date: Nov 2015 Location: Seligman, MO Posts: 642	Could anyone with an inline 6 help? Would anyone with a '63-'66 Chevy/GMC truck and an inline 6 take some measurements for me? I am installing a 292 in a '66 GMC with aftermarket frame/engine mounts and want to get it in roughly the factory placement, but the factory crossmember is gone. Even just sharing pictures would help a lot. 1. Distance from front of block to frame cross braces that the radiator sits on. 2. Distances from left and right frame to center of crank snout/harmonic balancer. 3. What degree should the engine be leaning back? These will greatly help me install my 292. Thanks!

05-29-2023, 12:09 PM	#2
SOON2BLAZE Account Suspended Join Date: Aug 2005 Location: Southern UT Posts: 906	Re: Could anyone with an inline 6 help? I'll grab some measurements this afternoon and PM you.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.