NY WTB Air Cleaner Lid for 6 cylinder

[georgieb51]

Hello Folks,
I am trying to find just the lid for my air cleaner. The air cleaner shown in the phots came from something else and the original top prevents my hood from closing. I just need a flatter one (as shown in the phots 1 and 5), the one that is primer gray and has rust holes. The photos have measurements, but in general this lid is smaller than the large ones on my quadrajet. The base of the aircleaner (photo 3) is 12 1/2" and the outer diameter of the existing lid (photo 4) is apprxximately 13" Thank you.

[georgieb51]

The black lid is too tall and I need a flatter lid. This fits on a 1 barrel carb.

[georgieb51]

I still need a lid for my small air cleaner. Any suggeestions?

[Orange71shorty]

I might have one I’ll try and look today

[georgieb51]

Originally Posted by orange71shorty

i might have one i’ll try and look today

thank you!

[Orange71shorty]

I found my base but can’t seem to find the lid! I’ll keep looking

[georgieb51]

Originally Posted by Orange71shorty

I found my base but can’t seem to find the lid! I’ll keep looking

Thanks for not giving up. I have a lid (as you can see the one that is primed) but it is rusty and full of holes). I cannot seem to find an aftermarket lid either. They sell lids that are 14"diameter but they are just a bit too large.

[Dirt's72]

I have two of these lids you are looking for. One is nicer than the other and I want to keep together with a 72 6 cylinder exhaust manifold shield with metal pipe to air cleaner. The other one I have is in good shape overall just some blemishes where the wingnut screws on. I also have a complete set up of a monojet gm air cleaner with lid that is slightly smaller (12 1/2"). PM me your email or phone number and I can send you pictures.

[georgieb51]

Originally Posted by Dirt's72

I have two of these lids you are looking for. One is nicer than the other and I want to keep together with a 72 6 cylinder exhaust manifold shield with metal pipe to air cleaner. The other one I have is in good shape overall just some blemishes where the wingnut screws on. I also have a complete set up of a monojet gm air cleaner with lid that is slightly smaller (12 1/2"). PM me your email or phone number and I can send you pictures.

I wlil PM yo and see what you have. Thanks

[georgieb51]

PM sent to Dirt's72. AND I am still hoping someone will be able to help me out. I think this is the same aircleaner found on a lot of the 6 cylinder engines.

[Warrens69GMC]

maybe?

https://www.ebay.com/itm/12594572307...Bk9SR_yw9cKrYg

[NGN]

Not exactly sure but I think that lid would come off a 67 year and down. The vehicles with less emissions, again not exactly sure.
NGN
NICK

[georgieb51]

Originally Posted by Warrens69GMC

maybe?

https://www.ebay.com/itm/12594572307...Bk9SR_yw9cKrYg

Thanks for keeping your eye out. That lid was just 1/2" too small. I need a full 13". I think I have the right part coming from dirt 72.

[georgieb51]

Originally Posted by NGN

Not exactly sure but I think that lid would come off a 67 year and down. The vehicles with less emissions, again not exactly sure.
NGN
NICK

I think you are right about that. I have an old rusty one that fits perfectly that came off a 67.

[georgieb51]

I want to thank everyone for their help with this. Thanks to dirt 72 I think I have the correct items coming my way.