|
03-11-2004, 04:37 AM
|
#1 |
|
Registered User
Join Date: Jul 2001
Location: Laughlin, Nv. USA
Posts: 700
|
More progress & parts
Well I am making some progress after being
down for a few months with my cracked block and my back injury. I started the body work a week ago, and got my rear lowering suspension and my X-pipe for my exhaust. I plan on getting the rear parts on by Friday, then taking it to get the front end aligned and exhaust installed by next week. Then it's off to the body shop for fender/door/hood alignment and a primer coat.     more at : http://www.unlimited2u.com/marapr2004 |
|
|
|
03-11-2004, 06:40 PM
|
#2 |
|
Genuine Chevrolet
Join Date: Feb 2003
Location: South West Pennsylvania.
Posts: 582
|
That's some serious trim removal your doing. Did you get any warpage when you did the bed sides? I need to fill all the holes where I removed the tarp snaps on mine.
__________________
George 82 Silverado LWB 4x4 350 SM465 NP208 77 Chevrolet Blazer Chalet 400 TH350 NP203 |
|
|
|
|
03-11-2004, 10:05 PM
|
#3 |
|
yeller
Join Date: Oct 2001
Location: Twin Cities
Posts: 13,824
|
I did the same thing you are doing back in 96...if I remember right, there was over 40 trim holes to fill on my truck!
Took me foooorrrrreeevvvveeeerrrrr to get it ready for paint. Keep your head buried and stay motivated...it will eventually end.  Good job so far!
__________________
Jeff 73-87.com 73-87.com Facebook page 73-87 cab corner 6x9 speaker brackets for sale 67-72 cab corner speaker brackets for sale 47-54 cab corner speaker brackets for sale |
|
|
|
|
03-12-2004, 04:08 AM
|
#4 |
|
Registered User
Join Date: Jul 2001
Location: Laughlin, Nv. USA
Posts: 700
|
Lucky thing was only the ends had holes,
middle was adhesive tape. But there were still 28 holes, I had them welded then just a thin topcoat of filler to cover the uneven weld after I ground it down. |
|
|
|
 |
| Bookmarks |
|
|
Bill 
Linear Mode
